KineticSystems Data Acquisition  
data acquisition products
pxi data acquisition products
vxi data acquisition products
camac data acquisition products

Products

Products > CAMAC > CAMAC Equipment > 2000

CAMAC - 2000

Kluge Card

View Datasheet
Request
Ordering Information
 
 

ABOUT 2000
The Model 2000 single-width Kluge module allows circuit breadboarding for one-of-a-kind or prototype work. A standard CAMAC-size, double-sided PC board with connections to the Dataway and the I/O connector, it comes complete with mounting hardware. The rear I/O connector is available as a 36-position edge connector, a 52-pin "2DB," or a 25-pin "DB" connector. Two holes are available for wiring at each IC pin. The wiring is geneally done on the component side with 28-gauge, "wire-wrap" type wire.

Ten rows of IC pads accommodate up to 73 standard 14-pin DIP ICs or 63 16-pin DIPs. Two rows of pads accept IC packages with 0.600-inch pin spacing. Additional rows of larger sized ICs are also accommodated by overlapping ICs between the standard sized and wider rows of pads.

 

Features
  • Complete CAMAC breadboarding kit
  • Occupies only one CAMAC slot
  • Pads for ICS with 0.300-inch and 0.600-inch pin spacing
  • Uncommitted pad layout allows use of longer MSI and LSI ICs in circuit prototyping
  • Layout provided for regulators on +/-24 V lines
Applications
  • Circuit breadboarding
  • CAMAC prototype development
  • “Special” CAMAC modules

Return to Product Category

Search Site   Go 
 GaGe | DynamicSignals © DynamicSignals, LLC. 2006 | Site Map