3072
CAMAC 48-Bit Output Register Module

The 3072 is a single-width CAMAC module with 48 output switches. These switches are organized as two 24-bit words. Each switch is an open-collector transistor suitable for driving a relay, lamp, solenoid, or similar device.

All of the switches share a commo n return path. An output switch is closed whenever there is a 1 in the corresponding bit of the data register. Each output can sink 250 mA with a maximum open-circuit voltage of 30V. Inductive loads should be diode-clamped at the load to remain within the voltage rating. Internal diode suppression clamped to +24V is available as an option. The 3072 is also available with pull-up resistors for TTL signal levels.

CAMAC 48-Bit Output Register Module: 3072

3072 Data Sheet

Supporting Chassis

US Prices Start at: $(Consult)

Request Quote

Three connector options are available: a 52-pin, "2D" connector at the rear of the module above the Dataway and either a 50-contact Amphenol ribbon connector or a 50-pin "D" type connector on the front panel.

CAMAC Module Features

  • 48 Output Switches
  • 30V Open-Circuit Rating
  • 250 mA Current Drive per Switch
  • Diode Clamping Option
  • TTL Output Option

CAMAC Module Ordering Information

3072 Products and Part Numbers
Output Register, 48-Bits, Open-Collector Output,
50S Amphenol Ribbon Connector
3072-A1A
Output Register, 48-Bits, Diode Clamp,
50S Amphenol Ribbon Connector
3072-A1B
Output Register, 48-Bits, TTL Pull-Up Resistor,
50S Amphenol Ribbon Connector
3072-A1C
Output Register, 48-Bits, Open-Collector Output,
50P "D" Connector
3072-E1A
Output Register, 48-Bits, Diode Clamp,
50P "D" Connector
3072-E1B
Output Register, 48-Bits, TTL Pull-Up Resistor,
50P "D" Connector
3072-E1C
Output Register, 48-Bits, Open-Collector Output,
52P "2D" Connector
3072-F1A
Output Register, 48-Bits, Diode Clamp,
52P "2D" Connector
3072-F1B
Output Register, 48-Bits, TTL Pull-Up Resistor,
52P "2D" Connector
3072-F1C